+- SA Classic Mini Forum (https://samini.co.za)
+-- Forum: Technical Stuff (https://samini.co.za/forumdisplay.php?fid=14)
+--- Forum: Technical Queries / Questions - Classic Mini (https://samini.co.za/forumdisplay.php?fid=15)
+--- Thread: Pre verto clutch (/showthread.php?tid=750)
Pre verto clutch - Adriaan Roos - 10-05-2017
Hi
The "biting" point of the clutch is against the floor. The first thing I notice was that the lock nut for adjustment was missing.
I have now screwed in a lock nut. If understand correctly to set the biting point higher I have to screw out the throwout stop nuts first. I must then pull the arm away from the engine, loosen the lock nut and unscrew it until it contacts the arm. Then I must screw it back 0,1mm. My problem is that the arm only move about 3mm if I pull it back by hand. Is it suppose to have so little movement.
Regards
Corno
RE: Pre verto clutch - Cooper1275 - 10-06-2017
http://www.calverst.com/technical-info/clutch-adjustment/
This article describes the process the best
RE: Pre verto clutch - Adriaan Roos - 10-06-2017
(10-06-2017, 09:34 AM)Cooper1275 Wrote: http://www.calverst.com/technical-info/clutch-adjustment/
This article describes the process the best
Hi
Thank you.
Regards
Adriaan
RE: Pre verto clutch - Pumba - 10-07-2017
Excellent advice there - Calver is one of the mini legends