Charlie - Mini Mk3

[Jared Mk3]

I did the passenger side air vent deflector this afternoon. Polished the brackets and then took the protective film off the the plastic. Looks like this from the inside :
 

 
And from the outside :
 

 
Probably could have done a better job, but hey. I wanted to do the other side as well, but I forgot I haven't got a heater pipe yet - doh. So I need to find a second hand one for that side.

---

I rounded off the corners of the deflectors today and got them mounted properly. Job done :
 

 
Also, to louvre, or not to louvre?
 

---

I had a brain fart and put the heater pipe bracket on without the secondary bracket for the fuel line underneath it. Well, today that was rectified. I just need to get a grommet of some kind on there to protect the pipe and maybe a little protective paint as well. There's still room for adjustment should it be needed.
 

---

And to divide opinion even further, I bought these :
 

 
Now to keep them clean. I still need to get an extension for the clutch MC.

---

First coat of primer is on and smoothed down. It needs another coat or two and then sanding smooth and they'll be good to go.
 

---

Decided I want to do something different for the ignition key :
 

 
Works quite well, not too heavy either :
 

---

I finally got around to sorting out the centre switch panel mounting :
 

 
I didn't get a picture of what the plate looks like. She needs a real good clean inside and out.

---

And because I didn't get a picture the other day, here it is :
 

 
I had both cars out today as well :
 

 
The Mk3 is in need of a good wash.

---

I made a start on the board for the parcel shelf today. Still lots of work to do, but it's a start :
 

 
Need to decide now if I want speakers on the board or not.