09-24-2018, 03:09 PM
Loosely fitted the starter motor after giving it some paint. Also fitted decent clamps on the water hoses. Lastly, the original tappet chest plate was cleaned up and painted, then fitted with some new seals on the bolts.
![[Image: lK3Mq63.jpg]](https://i.imgur.com/lK3Mq63.jpg)
I also got the old loom out, ready to fit the new one. There are a few differences which I will be accommodating for before fitting the new loom. I also need to decide if I want to be replacing the rear loom too - not sure I have enough patience to feed it through the roof.
Old vs new :
![[Image: O6hFMy6.jpg?1]](https://i.imgur.com/O6hFMy6.jpg?1)
Removed everything I needed to for fitting the sound proofing on the bulkhead. Couple of things I need to do before I get fit it properly. Also having to strip out most of the dash etc. One step forward, three steps back :
![[Image: rk7DNnz.jpg]](https://i.imgur.com/rk7DNnz.jpg)
I also got the old loom out, ready to fit the new one. There are a few differences which I will be accommodating for before fitting the new loom. I also need to decide if I want to be replacing the rear loom too - not sure I have enough patience to feed it through the roof.
Old vs new :
Removed everything I needed to for fitting the sound proofing on the bulkhead. Couple of things I need to do before I get fit it properly. Also having to strip out most of the dash etc. One step forward, three steps back :
![[Image: XLqVNZw.jpg?1]](http://i.imgur.com/XLqVNZw.jpg?1)
![[-]](https://samini.co.za/images/collapse.png)