01-16-2020, 09:51 AM
Haven't updated this thread in quite a while, but there really hasn't been much progress on the Mini either.
Had a bit of a stuff up in early December, reversed into a tree stump and dinged the rear bumper, so for the end of year car show, the Mini was bumperless and not looking great :\
The Mini was soon after parked up as I went home for the holidays.
![[Image: G2MKbAn.jpg]](https://i.imgur.com/G2MKbAn.jpg)
I had picked up a secondhand rear bumper that was straight and usable. Cleaned it up and then gave it a good polish and it turned out alright I think.
![[Image: 23jkeZx.jpg]](https://i.imgur.com/23jkeZx.jpg)
![[Image: 0ZKhPFK.jpg]](https://i.imgur.com/0ZKhPFK.jpg)
The Mini is currently parked up as the top and bottom engine steadies are completely stuffed. The bolt has rusted to the sleeve of the top one and I can't get that loose to replace it, while the nut is seized onto the lower steady and the bush is also completely worn. I have the bushes to replace these parts but don't currently have the skill to get the bolts off. I think a hacksaw is needed or perhaps an angle grinder.
Had a bit of a stuff up in early December, reversed into a tree stump and dinged the rear bumper, so for the end of year car show, the Mini was bumperless and not looking great :\
The Mini was soon after parked up as I went home for the holidays.
![[Image: G2MKbAn.jpg]](https://i.imgur.com/G2MKbAn.jpg)
I had picked up a secondhand rear bumper that was straight and usable. Cleaned it up and then gave it a good polish and it turned out alright I think.
![[Image: 23jkeZx.jpg]](https://i.imgur.com/23jkeZx.jpg)
![[Image: 0ZKhPFK.jpg]](https://i.imgur.com/0ZKhPFK.jpg)
The Mini is currently parked up as the top and bottom engine steadies are completely stuffed. The bolt has rusted to the sleeve of the top one and I can't get that loose to replace it, while the nut is seized onto the lower steady and the bush is also completely worn. I have the bushes to replace these parts but don't currently have the skill to get the bolts off. I think a hacksaw is needed or perhaps an angle grinder.