11-15-2020, 07:13 AM
Fitted the studs and gasket for oil filter housing
Next filter housing fitted with feeder tube. Starter and cooling fan and pulley.
Sourced and fitted missing welch plug.
Due to size differences in the LCB flange and inlet manifold flange, I had to resort to this....
I had these manifold washers that was welded up from a client's job, so I needed to remove some metal as the difference was about 0.25 to 0.3 mm between the two flanges. Then the final result is this....
Once properly torqued down and in place....
Lastly for the day fitted the carb and filter back.
Next filter housing fitted with feeder tube. Starter and cooling fan and pulley.
Sourced and fitted missing welch plug.
Due to size differences in the LCB flange and inlet manifold flange, I had to resort to this....
I had these manifold washers that was welded up from a client's job, so I needed to remove some metal as the difference was about 0.25 to 0.3 mm between the two flanges. Then the final result is this....
Once properly torqued down and in place....
Lastly for the day fitted the carb and filter back.
Own some minis, break them, fix them, improve them, test them to the limit....
![[-]](https://samini.co.za/images/collapse.png)