06-09-2021, 06:37 AM
Kicking up the originality factor a few notches. Was looking at some engine bay pics of GTSs and GTs and saw I needed some clips. So I stole the clips for harness to inner wings from my spare GTS and fitted them.
Now I was undecided about the p-clip for the wiring near the brake master, but the spare GTS and stripped 1275E both had it so I stole it again and fitted it.
The starter solenoid was still not up to scratch so I remembered that I bought boots for the main cables yonks ago, so they were fitted.
Got some single bullet connectors and replaced 10 double bullet connectors with the single connectors. The new loom differs from a SA loom where the wires connect to the rear loom in the way that it has only the male bullet brass connectors, where the SA loom had insulated female bullet connectors this is why the single double connectors is needed.
Now I was undecided about the p-clip for the wiring near the brake master, but the spare GTS and stripped 1275E both had it so I stole it again and fitted it.
The starter solenoid was still not up to scratch so I remembered that I bought boots for the main cables yonks ago, so they were fitted.
Got some single bullet connectors and replaced 10 double bullet connectors with the single connectors. The new loom differs from a SA loom where the wires connect to the rear loom in the way that it has only the male bullet brass connectors, where the SA loom had insulated female bullet connectors this is why the single double connectors is needed.
Own some minis, break them, fix them, improve them, test them to the limit....
![[-]](https://samini.co.za/images/collapse.png)