09-13-2015, 07:34 PM
(This post was last modified: 09-13-2015, 07:34 PM by Richie Rich.)
Another weekend has passed but never had as much time as I would have liked, I managed to do a bit of work, but ran out of time which I needed to clean up the welds, not allowed to make noise on SundaysÂ
Trimmed the extra metal so the body lines met, and cleaned off the epoxy ready for welding
While having the floor pans bent, I had other pieces bent for welding up around the floor pan. Also 2mm at various angles.
This was cut and bent to suit the profile and then drilled for welding.
Today, managed to get some welding done, just need some time to clean up the welds.
Will post more pics once the welds have been cleaned. Not so easy welding at that angle, now I know why guys spend the money and build rotisseries. I also wont do so many spot welds next time, just a couple to hold the panel in place.
Trimmed the extra metal so the body lines met, and cleaned off the epoxy ready for welding
While having the floor pans bent, I had other pieces bent for welding up around the floor pan. Also 2mm at various angles.
This was cut and bent to suit the profile and then drilled for welding.
Today, managed to get some welding done, just need some time to clean up the welds.
Will post more pics once the welds have been cleaned. Not so easy welding at that angle, now I know why guys spend the money and build rotisseries. I also wont do so many spot welds next time, just a couple to hold the panel in place.