08-11-2016, 11:07 AM
You don't need a compression tool, you can remove the top control arm and this frees up the cone and donut assembly.
If you want to use a compression tool it is a rather simple and cheap device to make.
I made one using a length of threaded rod, a few nuts and big washers, and a section of 25x25 square tubing.
If you want to use a compression tool it is a rather simple and cheap device to make.
I made one using a length of threaded rod, a few nuts and big washers, and a section of 25x25 square tubing.
![[-]](https://samini.co.za/images/collapse.png)