02-06-2017, 08:24 AM
I'm assuming those steel pipe join sections are just straight pipe - that will never hold and your pipes will push off under pressure.
You need to either get barbed sections, or just create your own - nice DIY trick (which I used on the boost pipes on my 200SX) is to weld a couple of spots on the pipes as this will prevent the rubber pipes from slipping off
You need to either get barbed sections, or just create your own - nice DIY trick (which I used on the boost pipes on my 200SX) is to weld a couple of spots on the pipes as this will prevent the rubber pipes from slipping off
I'm only here to LOL and +1