Hi Guys
I have a GTS cluster that has a newish printed circuit, yet this did not solve my rev counter problem. The rev counter is not working at all.
I am using an electronic ignition kit (Accuspark).
I am using the white wire with the black tracer from the negative on the coil to the back of the rev counter.
Then from the voltage stabilizer on the B connector (I think) a wire is run to the spade connector on the back of the rev counter.
The rev counter is the RCV type 12 volt negative earth.
Any ideas or proper wiring/ diagram will be highly appreciated.
Thanks
I have a GTS cluster that has a newish printed circuit, yet this did not solve my rev counter problem. The rev counter is not working at all.
I am using an electronic ignition kit (Accuspark).
I am using the white wire with the black tracer from the negative on the coil to the back of the rev counter.
Then from the voltage stabilizer on the B connector (I think) a wire is run to the spade connector on the back of the rev counter.
The rev counter is the RCV type 12 volt negative earth.
Any ideas or proper wiring/ diagram will be highly appreciated.
Thanks
Own some minis, break them, fix them, improve them, test them to the limit....