I was asked about my current set up to help with some troubleshooting on a 28/36 DCD Weber Downdraft and I used this image for reference so I thought to share it.
It is only part of Fig 7.9b on page 99 of David Vizard's "Tuning the A-Series Engine" focusing on 1098 & 1275 engines; so I reckon it should be OK to share. It would be the same as me typing a few lines out
The left hand numbers column refers to the primary barrel and the right hand side, the secondary barrel. All using F30 emulsion tubes.
If I get around to stripping and rebuilding mine, I might do a guide on that too.
It is only part of Fig 7.9b on page 99 of David Vizard's "Tuning the A-Series Engine" focusing on 1098 & 1275 engines; so I reckon it should be OK to share. It would be the same as me typing a few lines out
The left hand numbers column refers to the primary barrel and the right hand side, the secondary barrel. All using F30 emulsion tubes.
If I get around to stripping and rebuilding mine, I might do a guide on that too.