These are not my designs, but I am collecting some while contemplating getting a 3D printer or outsourcing the printing:

Classic Mini Ashtray Charger Box

Classic Mini Copper Logo Keyring

Classic Mini Cooper Logo

Classic Mini 12V Panel

Classic Mini Glovebox

Classic Mini Pickup Air Inlet Bracket

Classic Mini Towing Frame

Classic Mini Windshield Washer Reservoir Cap

Classic Mini Speedometer Gear

Austin Mini Miniature

Are any of the members of this forum into 3d printing?  I think there could be a market for steering wheel column covers, replacement lenses, logos, spare parts, etc.

Hi Everyone,

as per my build thread my old engine is for sale R5000 neg. available in Johannesburg and will be at piston ring on the 18/09/2016

Dear SA forum members

I would like to enquire if anyone has a set of disk brakes including caliper (to fit a clubman) for sale? I plan on keeping the old school 10inch rims and would like to upgrade the brakes.
I've considered the golf conversion however it means that I would need to change up to 13inch tyres. I believe the 10inch still gives you the best "go kart ride".
Any advice in this regard, will be much appreciated.

Imported boot lid, very good condition excluding handle R1000.

Mine..............

From about 12 years ago.

My sisters Mini back in the day, used to use a shed load of oil....

and sometimes, like often, she would forget to check and top it up....

This resulted in the piston seizing and parting company with the con rod.........

Care off Glen Tayfield Durban

This is what 1 bar boost did to standard pistons within 40 kays on my boosted 16v 1600 Opel/Daewoo motor.